Brilliant NSE7_SDW-6.4 Exam Dumps Get NSE7_SDW-6.4 Dumps PDF
NSE7_SDW-6.4 Dumps PDF - NSE7_SDW-6.4 Real Exam Questions Answers
Fortinet NSE7_SDW-6.4 Exam Syllabus Topics:
| Topic | Details |
|---|---|
| Topic 1 |
|
| Topic 2 |
|
| Topic 3 |
|
| Topic 4 |
|
| Topic 5 |
|
NEW QUESTION 12
Refer to the exhibit.
What must you configure to enable ADVPN?
- A. On the hub VPN, only the device needs additional phase one sett
- B. Each VPN device has a unique pre-shared key configured separately on phase one
- C. The protected subnets should be set to address object to all (0.0 .0. o/o).
- D. ADVPN should only be enabled on unmanaged FortiGate devices.
Answer: B
NEW QUESTION 13
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )
- A. Specify outgoing interface routing cost.
- B. Configure SD-WAN rules interface preference.
- C. Select SD-WAN balancing strategy.
- D. Specify incoming interfaces in SD-WAN rules.
Answer: A,B
NEW QUESTION 14
Refer to the exhibit.
Which statement about the trace evaluation by FomGate is true?
- A. Packets exceeding the configured concurrent connection limit are dropped based on the priority configuration.
- B. The packet exceeded the configured maximum bandwidth and was dropped by the shared shaper.
- C. Packets exceeding the configured maximum concurrent connection limit are denied by the per-IP shaper.
- D. The packet exceeded the configured bandwidth and was dropped based on the priority configuration.
Answer: C
NEW QUESTION 15
Refer to the exhibit.
Which two statements about the status of the VPN tunnel are true? <Choose two )
- A. There are separate virtual interfaces for each dial-up client.
- B. FortiGate created a single IPsec virtual interface that is shared by all clients.
- C. VPN static routes are prevented from populating the FortiGate routing table.
- D. 100.64.3.1 is one of the remote IP address that comes through index interface 1.
Answer: B,D
NEW QUESTION 16
What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two.)
- A. It improves SD-WAN performance on the managed FortiGate devices.
- B. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
- C. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
- D. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
- E. It acts as a policy compliance entity to review all managed FortiGate devices.
Answer: B,E
NEW QUESTION 17
Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?
- A. diagnose sys virtual-wan-link intf-sla-log
- B. diagnose sys virtual-wan-link log
- C. diagnose sys virtual-wan-link health-check
- D. diagnose sys virtual-wan-link sla-log
Answer: D
Explanation:
Explanation/Reference: https://docs.fortinet.com/document/fortigate/6.2.0/cookbook/943037/sla-logging
NEW QUESTION 18
Refer to exhibits.
Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.
Based on the exhibits, which statement is correct?
- A. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
- B. SD-WAN member interfaces are affected by the SLA state of the inactive interface
- C. Port1 became dead 1ecause no traffic was offload through the egress of port1.
- D. Both SD-WAN member interfaces have used separate SLA targets.
Answer: A
NEW QUESTION 19
Which three parameters are available to configure SD-WAN rules? (Choose three.)
- A. Application signatures
- B. Type of physical link connection
- C. Source and destination IP address
- D. Internet service database (ISDB) address object
- E. URL categories
Answer: B,C,D
NEW QUESTION 20
Refer to the exhibit.
Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?
- A. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
- B. FortiGate has terminated the session after a change on policy ID 1.
- C. Firewall policy ID 1 has source NAT disabled.
- D. Changes have been made on firewall policy ID 1 on FortiGate.
Answer: D
NEW QUESTION 21
Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?
- A. Each IP is guaranteed a minimum 10 Mbps of bandwidth
- B. A single user uses the allocated bandwidth divided by total number of users.
- C. The 10 Mbps bandwidth is shared equally among the IP addresses.
- D. FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
Answer: D
NEW QUESTION 22
Refer to the exhibit.
FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)
- A. Use different proposals are used between the interfaces.
- B. Use unique Diffie Hellman groups on each VPN interface.
- C. Specify a unique peer ID for each dial-up VPN interface.
- D. Configure the IKE mode to be aggressive mode.
Answer: A,B
NEW QUESTION 23
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?
- A. The dead member interface stays unavailable until an administrator manually brings the interface back.
- B. Check interval is the time to wait before a packet sent by a member interface considered as lost.
- C. The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.
- D. Port2 needs to wait 500 milliseconds to change the status from alive to dead.
Answer: C
NEW QUESTION 24
Which diagnostic command can you use to show the SD-WAN rules interface information and state?
- A. diagnose sys virtual-wan-link member.
- B. diagnose sys virtual-wan-link route-tag-list
- C. diagnose sys virtual-wan-link service
- D. diagnose sys virtual-wan-link neighbor.
Answer: A
NEW QUESTION 25
Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )
- A. A peer ID is included in the first packet from the initiator, along with suggested security policies.
- B. A total of six packets are exchanged between an initiator and a responder instead of three packets.
- C. XAuth is enabled as an additional level of authentication, which requires a username and password.
- D. The use of Diffie Hellman keys is limited by the responder and needs initiator acceptance.
Answer: B,C
NEW QUESTION 26
Refer to exhibits.
Exhibit A.
Exhibit B.
Exhibit A shows the SD-WAN rules and exhibit B shows the traffic logs. The SD-WAN traffic logs reflect how FortiGate processed traffic.
Which two statements about how the configured SD-WAN rules are processing traffic are true? (Choose two.)
- A. SD-WAN rules are evaluated in the same way as firewall policies: from top to bottom
- B. The All_Access_Rules rule load balances Vimeo application traffic among SD-WAN member interfaces
- C. The initial session of an application goes through a learning phase in order to apply the correct rule
- D. The implicit rule overrides all other rules because parameters widely cover sources and destinations.
Answer: C,D
NEW QUESTION 27
What is the lnkmtd process responsible for?
- A. Processing performance SLA probes
- B. Flushing route tags addresses
- C. Monitoring links for any bandwidth saturation
- D. Logging interface quality information
Answer: D
NEW QUESTION 28
......
Valid NSE7_SDW-6.4 Test Answers & Fortinet NSE7_SDW-6.4 Exam PDF: https://pass4sure.testvalid.com/NSE7_SDW-6.4-valid-exam-test.html